Overview: WhirlJet Standard, Wide and Extra Wide Angle Nozzles

• Hollow cone spray pattern with a circular impact area
• Large, unobstructed flow passages minimize clogging
• Good atomization of liquids at lower pressures – ideal for fluid cooling applications
• Removable caps for easy inspection and cleaning on some models
• Slope-bottom design models reduce the drilling effect of the fluid vortex in the fluid chamber and premature wear
• AX and BX nozzles form smaller drops; ideal for use in air washers and dust suppression applications
• CX, CF, CRC and D nozzles feature higher flow rates; ideal for use in larger, evaporative cooling spray ponds 
• AP, LAP and LBP nozzles are constructed of polypropylene and feature excellent corrosion resistance at temperatures up to 160°F (71°C); patented center post design provides extended wear life of the nozzle
• Standard, wide and extra wide spray angles

WhirlJet Nozzles

As liquid enters the nozzle, it passes into a whirlchamber and begins to spin in a circle at high speed. The rotation forces the liquid away from the center toward the edges of the whirlchamber. This 
causes the liquid to exit the orifice in a hollow cone pattern. Some WhirlJet nozzles have a slope bottom in the whirlchamber that helps extend wear life.

WhirlJet AX, BX, CX and D Nozzles

• Spray angles: Standard – 43° to 91°, Wide – 112° to 120°
• Uniform spray distribution:
  – AX and BX nozzles – from .03 to 38 gpm (.19 to 145 lpm)
  – CX, CRC, CF and D nozzles – from 2.0 to 2362 gpm (7.3 to 9010 lpm)
• Operating pressures from 3.0 to 100 psi (0.2 to 7.0 bar)

Contact your local sales engineer for information about junction boxes.

Whirljet Options

Relative Drop Size In Microns

Drop size will vary based on flow rate and pressure.

Whirljet AP, LAP, LBP And E Nozzles

• Spray angles: Standard – 43° to 91°, Wide – 112° to 120°, Extra wide – 144° to 165°
• Uniform spray distribution:
  - AP, LAP and LBP nozzles – from .14 to 18.9 gpm (.20 to 15.9 lpm)
  - E nozzles – from .11 to 16.8 gpm (.41 to 64 lpm)
• Operating pressures from 3.0 to 100 psi (0.2 to 7.0 bar)

Whirljet Options

Ordering Information

Quick Reference Guide

F = female thread; M = male thread. There is no material code for brass. Leave material code blank when ordering. Other materials available upon request.

For more dimensions and sizes, contact your sales engineer.

Performance Data

Intermediate capacities: Caps are interchangeable for in-between capacities within each pipe size group. Request Data Sheets 3055, 3986 and 3987.
Spray dimension data: Request Data Sheets 15350 and 15362.
Highlighted column shows the rated pressure (10 psi).